P1074464_wt.7z

: If a face is too complex, use a "Split Line" to break it into smaller segments before applying the draft to each part individually.

: This is the standard method where you select a "neutral plane" that determines the pull direction. The draft angle is then applied to the faces you select, pivoting them from that plane. p1074464_wt.7z

: Often used for more complex geometry, this method allows you to use a specific edge or curve as the split point for the draft. This is highly recommended for parts with non-planar divisions. : If a face is too complex, use

If the standard feature fails (which often happens on complex surfaces like fenders or casting pockets), consider these professional workarounds: : Often used for more complex geometry, this

To draft a feature using the file (which likely contains a CAD model for a casting or molded part), you should apply a Draft feature to the relevant faces. This feature creates a taper that allows the part to be extracted from its mold easily.

Based on community discussions regarding similar drafted features, here is how you can effectively apply a draft: